By using MOVI2R+MOVI2R+CSEL in the zero case instead of doing bitwise
operations on the output of the other MOVI2R+MOVI2R+CSEL, we avoid using
BFI, an instruction that takes two cycles on most CPUs. The instruction
count is the same and the pipelining should be at least equally good.
This is a little trick I came up with that lets us restructure our float
classification code so we can exit earlier when the float is normal,
which is the case more often than not.
First we shift left by 1 to get rid of the sign bit, and then we count
the number of leading sign bits. If the result is less than 10 (for
doubles) or 7 (for floats), the float is normal. This is because, if the
float isn't normal, the exponent is either all zeroes or all ones.
Not sure if this was causing correctness issues – it depends on whether
the HLE code was actually reading the discarded registers – but it was
at least causing annoying assert messages in one piece of homebrew.
Nowadays, basically everything except for controller config is handled
by the new config system. Instead of enumerating the systems that are,
let's enumerate the systems that aren't.
I've intentionally not included Config::System::Session in the new list.
While it isn't intended to be saved, it is a setting that's fully
handled by the new config system. See
https://github.com/dolphin-emu/dolphin/pull/9804#discussion_r648949686.
The point of farcode is to provide a separate location for code that
rarely runs, so that it doesn't pollute the icache. Taking a conditional
branch is something that happens very often, so the code for that
shouldn't be in farcode.
Some state changes are meant to be near instantanoues, before switching to something else. By reporting ithe instant switch, the UI will flicker between states (pause/play button) and the debugger will unnecessarily update. Skipping the callback avoids these issues.
This was implemented to prevent UI flickering due to the state rapidly switching between pause/play. Recently, it has been causing issues with debugger windows, which update during frame advance.
This way, the number of loop iterations is equal to the number of set
bits in the bitset rather than the number of bits in the bitset,
which is a good improvement because usually very few bits are set.
As far as I can tell, it has nothing to do with the mipmap/half_scale functionality, but does change based on the width of the destination texture (and the destination texture is half the width if half_scale is set). The comment that was there (which dates back to the initial megacommit) seems to not have accounted for the width aspect; it was first used as an actual stride in bbbe898839 (the first commit that used it at all).